![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() Joined Mar 23, '05 From Kansas City Currently Offline Reputation: 0 (0%) ![]() |
Hey, I was curious if anyone had suggestions on making a plate like this:
![]() ![]() I figured just take the boot off and measure all the clearances, draw it on some paper or cardboard then cut it out and lay it over the shifter to make sure the clearances are right before milling it in my college's shop. Any recommendations on shifter levers and knobs, or other general comments/suggestions? ~Brian -------------------- 1999 Celica GT
![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Nov 12, '02 From Webster Ma. Currently Offline Reputation: 1 (100%) ![]() |
i dont think it will work. the shifter doesnt move that far to fit in slots like that. all u would have is plate with a circle in the center. maybe really far up on the shifter it moves far away enough to fit slots. but down low where the leather boot is i dont think it will work. try it out though.
-------------------- |
![]() ![]() |
Lo-Fi Version | Time is now: May 28th, 2025 - 10:50 PM |