another 7afte w.specs Options

[playr158]

with a T3 50 trim .48 a/r w/internal wastegate
running a daily 1-2 psi and a "race" of 10-15psi
with an intercooler with dimensions of
24.5" x 12" x 3" controlled by a Profec E-01
(oh and i'm using a honda b16 Turbo manifold for the interest sake)

#1 can i do the 10-15psi range without issues?
#2 is it better to run external or internal wastegate with this setup, whats the difference
#3 is this intercooler sufficient enough to run the boost i'm using as the intercooler will be located in my fender as a SMIC
#4 the E-01 should be the only "controller" i'll need to run my system?
cause i will need to have the ability to switch boost levels on the fly, along with the needed engine control

thanks

This post has been edited by playr158: Apr 23, 2005 - 6:52 PM

[97sccelica]

with a T3 50 trim .48 a/r w/internal wastegate
running a daily 1-2 psi and a "race" of 10-15psi
with an intercooler with dimensions of
24.5" x 12" x 3" controlled by a Profec E-01
(oh and i'm using a honda b16 Turbo manifold for the interest sake)

#1 can i do the 10-15psi range without issues?
#2 is it better to run external or internal wastegate with this setup, whats the difference
#3 is this intercooler sufficient enough to run the boost i'm using as the intercooler will be located in my fender as a SMIC
#4 the E-01 should be the only "controller" i'll need to run my system?
cause i will need to have the ability to switch boost levels on the fly, along with the needed engine control

thanks
[right][snapback]276954[/snapback][/right]

b16 turbo manifold on a 7afe? who told you that would fit? bolt pattern is different, and i am pretty damn sure the exhaust port spacing will be off, and who's to say that it will place the turbo in the right place for a celica engine bay.

1. i wouldnt try too much over 10psi. 1-2psi daily is a joke, i dont even think they make wastegate springs that are below 3.5psi

2. external is more precise and consistant control. for your setup, its not needed, but it is the better, and more $$$ option

3. intercooler is a good size, more than you will ever need with out massive engine work, but how the hell will you fit that in the fender?

4. E-01 is a boost controller. it wont do anything engine management wise unless you run a Greddy Emanage.