I just won a SDS system on ebay, Its a stand alone engine management Options

[nik]

i just won the EM-3 4F
http://www.sdsefi.com/



so happy now i can sell my piggyback system and the AE101 harness and ECU

standalone will be way less of a wiring headache

Systems Include:
ECU
LCD programmer
Air temp sensor
Water or CHT sensor
Main wiring harness
Injector harness\
Fuel trim control, +, - 50%
Comprehensive manual
Crank sensor (E,F)
Timing magnets (E,F)
Coil/amp unit (F)
Adjustable Parameters
RPM - every 250
Manifold pressure - 64 locations
Water temperature - 32 locations
Start function - 33 adjustments
Acceleration - 3 adjustments
Closed loop - 5 adjustments
Boost limiting
Rev limiting
Ignition timing - every 250 (E,F)
MAP retard - 64 locations (E,F)
Knock control (optional on E,F)
RPM switch - every 250 (optional)
Nitrous ignition retard (E, F)
Fast idle temp cutoff - 32 locations (optional)
Data logging AFRs vs. RPM
Extra Cost and Optional Items
MAP sensors (1,2 and 3 Bar)
Knock sensors
Oxygen sensors (1 and 4 wire)
Fuel pump relays
Fast idle solenoids
Injectors
Fuel pumps
LED mixture meters
RPM switch
TPS
Electric fan switch relays
Supercharger switch relays
Air conditioning solenoids
15,000 rpm software
Backlit LCD programmer



The 4F system, shown above, controls fuel delivery and ignition timing on 4 cylinder engines to 9750 rpm (15,000 optional). Its crank triggered, direct fire coil pack replaces both distributor type and OEM distributorless ignitions. It is programmable in 250 rpm increments with 64 boost retard locations available for turbocharged engines and ignition retard under nitrous activation.

The standard F delivers a powerful, long duration spark and is suitable on engines with specific power outputs of up to 200hp/liter. With the addition of an MSD DIS, power levels can exceed 400hp/liter. The 4F comes complete with coils and crank trigger. Fabrication of a crank sensor mount and installation of trigger magnets is required


This post has been edited by nik: May 5, 2005 - 11:45 AM

[nik]

the update is just to add data logging
i agree with you on the no labtop thing
my emanger could see the whole map

now for the megasquirt thing

in short the shop i'm using is formiliar with sds and uses it alot the lastest being a S2000 pushing 600 horse

and the only dyno for miles knows how to tune the sds so it was a win win for me to get an sds i'm sure the megasquirt is a great system