LED Windshield Nozel Wiring, Id like to change it to turn signal Options

[red94celicagt]

Hey, i installed two red LED windshield nozels on my car and have the grounds going to a bolt in the engine compartment and the other power wires to the low-beam fuses so that the LEDs turn on when i turn on my headlights. This set up is alright for me for now, but eventually i would like to hook the power wire form the LEDs to the turn signal power wire, so that when i have my headlights on the LEDs remain on, but when i engage the turn signal left, left goes on and the right goes on with the right. I was wondering if this would work if i found the wire to the daylight driving lights (yellow ones on bumper) and connected them to the respective side, because when my headlights are on, so are those AND when you engage the turn signal, the corresponding side blinks. Assuming this to be correct, wouldnt the LEDs blink with the bumper lights? also if this would be true, where would i find the wires for the bumper lights? thanks again!

[cyb593]

they both have to flash cause u only have the one set of wire for the 2 lights. i just hooked mine to my sidemarkers so when ever my parking lights come on they come on but mine are blue.

[playr158]

they both have to flash cause u only have the one set of wire for the 2 lights. i just hooked mine to my sidemarkers so when ever my parking lights come on they come on but mine are blue.
[right][snapback]284176[/snapback][/right]

no they don't go look at your front turnsignal harness 3 wires dumbnut
1 flashes
1 is constant
1 is ground

2 filament bulbs