Body kit epoxy?, Fusion?? Options

[Rjb23]

I saw a post on here where someone used an epoxy to attach their body kit to the car. Anyone know where to get this stuff from? I think it was called fuzion or something like that.

[playr158]

you only screw the skirt on the inside of the door
which is under the kick panel so you can't see the screws

[Rjb23]

you only screw the skirt on the inside of the door
which is under the kick panel so you can't see the screws
[right][snapback]285365[/snapback][/right]

I don't know if the invader sides are different but my 404 sides from VIS fit like crap, or at least one side does. The part that fits into the door sill/jam I'm not sure how it is supposed to fit. I am trying to determine how it goes but I can't get pics of anyones. One side fits good and I have not problems with it, I am going to have to glue it to the side of the car, because the part that goes up the side near the rear wheel bends out, and will not stay in no matter how much I use a heat gun on it. The other side has a huge gap near the door jam and no matter how much I heat it up clamp it let it cool it doesn't get much better. That is another reason for me to use epoxy, even my body guy said he would have to screw it in or attach it in some way to make it fit right. See the VIS 404 gb thread for pics on how bad the fitment on these things are. Just the one side is really bad the passenger side is ok.

Here I'll post them here




there is really a thin rail of where I can screw it in at in the door jam, I'm worried the the fiberglass will crack easily.

This post has been edited by Rjb23: May 11, 2005 - 2:59 PM