im kinda lost, keyless entry Options

[Terzin1]

can someone give me at least a quick rundown on how to install the keyless part of my alarm. I have power locks that run on priority but im lost on what the hell wires to use, how to diode isolate shiot, and whatever else is needed. But HEY i did somehow get my alarm installed perfectly

[Cutrara]

If I remember, I'll take off my lower dash and snap a few pics for you and draw some diagrams for the diodes tomorrow.

Edit - This should help you with the diodes. You find the wires in the lower dash directly under the ignition switch there should be a blue box (I've heard on some models it may be black, but mine was blue) that says "Toyota Door Control Module" or something of the like. Disconnect the harness and splice into it, the wires you need.

Also, when you wire in the diodes for the keyless entry you will discover the wiring harness connected to the blue box is tight and hard to access. You will want to splice in the diodes like this:

instead of this:

Just because the first way is physically easier to wire.

Good luck, I'd like to get some actually pics for you. I'll try for that tomorrow. Also, I just noticed I accidently drew resistors in those diagrams. Diodes are usually black with a silver stripe on one side.

This post has been edited by Cutrara: Jun 15, 2005 - 11:18 PM