Trunk doesn't close correctly...I need help! Options

[Coomer]

Since my trunk was pried up, it doesn't close correctly now. I bent back the trunk lid metal a bit, and pulled the trunk seal off, and I can't figure out why the trunk lid won't close completely.

The trunk closes and latches, but it latches in a position that's way higher than it should and will not go down further. The trunk release lever no longer pops open the trunk, but the key will open the trunk. Also, when the trunk is latched, it will move up just a bit if you pull up on it, but only a little bit and then something catches and keeps the trunk closed unless you use the key to open it.

Anyone have any idea as to what might be happening? I think the prybar or whatever the thieves used may have pushed down the area by the latch too much.

Here's some pics:

Attached image(s)

 

[Batman722]

i know this has nothing 2 do with the topic, but you have 1) a very nice camera and 2) very good photo skills, if u dont mind, PM me with the type of camera you use, i might be interested in buying one for myself.
[right][snapback]301581[/snapback][/right]

nice

anyway, check the piece that is connected to the trunk itself. Maybe that is bent and needs to be tapped back in(it might look like a V instead of a U).

An easy fix might be to drill new holes for the latch assembly to lower it

the cable not opening it probably just need to be connected to the lever again. I just looked through my pics, I don't have one of my latch that would help, the only one I have is here