![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() Joined Nov 26, '03 From Texas Currently Offline Reputation: 1 (100%) ![]() |
when i last got my brakes redone (brakepads replaced and rotors smoothened [cant remember the rite word for smoothened]) and when i brake a certain amount, something in my back right wheel pops, i think it's the caliper, but i dont kno what would cause that, was it not put on right? my 2 front ones also pop but only when i reverse, and when i get out of my car and release my brake, my front ones pop but only once cuz when i try to do it again it doesnt do it, anyone kno what the problem might be?
-------------------- It's not just about getting from point A to point B anymore....
![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Dec 25, '02 From Pittsburgh/Clairton, PA Currently Offline Reputation: 1 (100%) ![]() |
uhh, iunno what's goin on
when i had my rears changed i got the same popping. it would happen the first time i applies the brakes after switching a direction of driving... aka pulling out of my garage in reverse, and then the first stop i do after pulling away... it stopped in time. At the time i had no ckue and just figured the brake pads were a bit smaller than the caliper had them made to be, and the front and back movement would stretch them out/break them in... -------------------- ![]() |
![]() ![]() |
Lo-Fi Version | Time is now: August 3rd, 2025 - 3:29 PM |