How much Psi??, on a 4age Options

[94silverst]

Just wondering what you guys think a turbo 4age (4agte?) would hold. I'm in the process of the 4age swap and am going to turbo it next summer. Interested in opinions!! Thanks!!!

[Coomer]

On a stock silvertop I wouldn't run more than 5-7 lbs. What do you plan to do as far as engine management for your turbo setup?

[nik]

On a stock silvertop I wouldn't run more than 5-7 lbs. What do you plan to do as far as engine management for your turbo setup?
[right][snapback]336859[/snapback][/right]

ditto i wouldnt go over 6 psi on t3 turbo you can swap the 4agze rods in there stronger but for more info go to club4ag they have 2 stickies on the silvertop over there. i would go with a smaller turbo to get some bottom end back

[Coomer]

ditto i wouldnt go over 6 psi on t3 turbo you can swap the 4agze rods in there stronger but for more info go to club4ag they have 2 stickies on the silvertop over there. i would go with a smaller turbo to get some bottom end back
[right][snapback]336903[/snapback][/right]

The silvertop's rods are just as strong as the AE101 4A-GZE rods...it's the high compression that prevents high boost levels.

[nik]

ditto i wouldnt go over 6 psi on t3 turbo you can swap the 4agze rods in there stronger but for more info go to club4ag they have 2 stickies on the silvertop over there. i would go with a smaller turbo to get some bottom end back
[right][snapback]336903[/snapback][/right]

The silvertop's rods are just as strong as the AE101 4A-GZE rods...it's the high compression that prevents high boost levels.
[right][snapback]336923[/snapback][/right]

I remeber reading that over there (club4ag) isnt the compression on a Silver top 10.5:1
i found a few places that have 5 valve pistons in lower comp like 9.0:1 and lower
but there spendy like $400+ not including rings and you need a manifold very hard to find one probably just have to have one custom made