 crankshaft timing gear |
 Sep 21, 2005 - 2:05 PM
|
 
|
|
Enthusiast  Joined Dec 2, '03 From Virginia Currently Offline Reputation: 0 (0%)  |
I can't figure out how to remove this gear, the chilton's and service manual just says use a puller. I have a 2 arm puller but the arms can't fit behind the rear sproket, and it seems like if it could it would bend it. Any suggestions?
|
 |
Replies
|
Sep 21, 2005 - 5:32 PM
|
|
|
Enthusiast Joined Feb 18, '04 From Spokane Washington Currently Offline Reputation: 0 (0%) |
I thought it showed using two screwdrivers on either end to pop it off? I will check tonight...
TJ |
Posts in this topic
Snarfer crankshaft timing gear Sep 21, 2005 - 2:05 PM
FallenHero I used a large flat screwdriver. Wedged it in the... Sep 21, 2005 - 5:43 PM Snarfer ok cool i was just worried about messing it up, th... Sep 21, 2005 - 11:00 PM FallenHero it's cast iron... you're not going to mess... Sep 22, 2005 - 2:02 AM
ice23q you need to use two large screwdrivers ....one on ... Oct 3, 2005 - 3:07 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: September 10th, 2025 - 1:05 PM |