Power Steering Pump Options

[Rjb23]

Did anyone else have to remove their power steering pump to get their 3s to fit right?

I had to remove mine because the pulley was hitting on my frame, I'm using the e153 tranny, the mr2 driverside, the GT front, and passenger and I plan on using the st205 rear.

[ems3s]

The mr2 mount is very close to fitting but I found that I spread the bracket on the frame a further 1/3 inch to make it just sit. When i tried this mount with gt front and 205 rear mounts it was putting the engine to far to the left and didn't line up.

I think that these are the part no's 1237174440 and 1237274500 for the rear mount and bracket both are needed. The insulator is offest to the left and the bracket is different too. I may be wrong about the part no's as I have a heap of receipts but can't remember what's what now. So please verify with your local toyota spare parts dealer.


I tried all sorts of combos but after spending lots on the wrong parts I ended up using

Gt front insulator and bracket (identical to 205 but diffirent part no's)
205 rear insulator and bracket
205 left side insulator and tranny bracket (bracket no longer available from toyota but possibly same as rav4 part)
Gt RH bracket and insulator. (indentical to 205)


Good Luck Let me know how you go.