![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() Joined Oct 1, '02 From Minnesota, USA Currently Offline Reputation: 0 (0%) ![]() |
OK. Well I got a new deck and I'm wanting to install it. I got the wiring harness for the 87up Toyota cars...but it wont go at all...not even close...BUT as I was looking online the GM one for 88up GM cars looks like it will match right up...hmmmm any ideas?
-------------------- 95 Toyota Celica GT
Dead for now --> Soon to have a 3S-GTE 02 WRX --> This is for speed - Borla Exhaust - TurboXS BOV - Custom CAI 02 Civic EX - MB Quart Reference 5.25" Components - Rockford MTX 8" Subs in the doors - Alpine Type S Rear Fills - 2x Alpine SWR-1042D Subs in a custom fiberglass box - Alpine F345 Amp for the front doors - Alpine M605 on each Type R - Phoenix Gold wiring - Alpine CDA-9855 Head Unit - Alpine Amp link - 2x Rockford Fosgate 1 Farad Caps - The best Viper 791 alarm install ever |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() Joined Oct 1, '02 From Minnesota, USA Currently Offline Reputation: 0 (0%) ![]() |
OK. I got ti all installed. Getting that factory wiring harness out was a b!tch. After I got it out of there...in which I think I snapped that plastic piece that holds it under the amp oh well...yeah I hooked it all up...ran into a few problems.
1) You have to make the power antenna go to the ground of one of the speakers. (At least I figured that out) 2) There was one extra little wire...not in the wiring harness at all...but kind looks like the anetnna wire but smaller...where does this go in my new deck? There's no place for it! On the stock deck it goes into a hole right next to the antenna wire bu on the new deck there's no spot for it. 3) OK...biggest problem. the sound sucks! My stock deck bumped a little...and I could at least make it loud without it going "kdsnmkgkdfjnaglokjfdanlkfjngag" actually its more of a scratchy sound...the louder I go the worse it gets. It doesn't come into effect until I get to about Volume 12. What the hell is wrong? i might go over my connections tomorrow again...take every one of them apart and resplice them...should you use solder to make sure the connections are secure because that may be the problem? Well thanks if nayone can fix this. So yeah..it's 10:45 and I start this at 9:30...not too bad considering I had to come online twice to ask questions. -------------------- 95 Toyota Celica GT
Dead for now --> Soon to have a 3S-GTE 02 WRX --> This is for speed - Borla Exhaust - TurboXS BOV - Custom CAI 02 Civic EX - MB Quart Reference 5.25" Components - Rockford MTX 8" Subs in the doors - Alpine Type S Rear Fills - 2x Alpine SWR-1042D Subs in a custom fiberglass box - Alpine F345 Amp for the front doors - Alpine M605 on each Type R - Phoenix Gold wiring - Alpine CDA-9855 Head Unit - Alpine Amp link - 2x Rockford Fosgate 1 Farad Caps - The best Viper 791 alarm install ever |
![]() ![]() |
Lo-Fi Version | Time is now: September 13th, 2025 - 1:02 PM |