6G Celicas Forums

Welcome Guest ( Log In | Register )

> Air duct falling down, Has this happened to anyone else?
post Jan 20, 2006 - 8:11 PM
+Quote Post
runriot95



Enthusiast
*
Joined Dec 1, '02
From Pittsburgh, PA
Currently Offline

Reputation: 0 (0%)




Yesterday while driving, I had a very harrowing experience when the air duct that connects the vents from the center console to the driver's side vents fell down.

This has happened a few times before but I was usually driving on a residential street and was able to stop and remove it. This time I was traveling on the highway when it happened and at first I though "no biggie" but then it started to get wedged down by the pedals.

Anyway, has anyone else had this recurring problem like I have? I think I fixed it pretty good but it's a pretty lousy design that doesn't seem to fit very well.
 
Start new topic
Replies
post Jan 21, 2006 - 8:30 AM
+Quote Post
Clipsetuner



Enthusiast
***
Joined Sep 12, '03
From Portland , Oregon , United States
Currently Offline

Reputation: -1 (33%)




Take the 2 panels off that are in front of the duct, there is 2 screws near the collom, and 1 screw beheind the kickpanel, and the other is in the bottom right, then there are 2 screws holding in the hood release. there is another panel beheind this one which is held on by 4 10mm bolts, take them out and it should fall off again, reinsert your air duct and you'll notice of the left side there is a little hole for a push pin, crappy design really, find a big screw, screw it into that hole, and fix'ed/

DTE


--------------------
I am a thief.
do not buy anything from me.
post Jan 21, 2006 - 11:32 AM
+Quote Post
runriot95



Enthusiast
*
Joined Dec 1, '02
From Pittsburgh, PA
Currently Offline

Reputation: 0 (0%)




QUOTE(Clipsetuner @ Jan 21, 2006 - 6:30 AM) [snapback]381821[/snapback]

Take the 2 panels off that are in front of the duct, there is 2 screws near the collom, and 1 screw beheind the kickpanel, and the other is in the bottom right, then there are 2 screws holding in the hood release. there is another panel beheind this one which is held on by 4 10mm bolts, take them out and it should fall off again, reinsert your air duct and you'll notice of the left side there is a little hole for a push pin, crappy design really, find a big screw, screw it into that hole, and fix'ed/

DTE


I DID notice that little hole on one of the ends of the duct. I didn't know what it was for but thanks for the tip!

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: October 27th, 2025 - 3:01 PM