plumbing for turbo (w/pics), is it to small? Options

[southwest2118]

Ok guys i went to pepboys and bought this to weld to my oil pan
what do you think? Its made for a 3/4" hose its 1-3/4' long and
the thread is 1/2" NPT. is it too small?












Then i went to Ace hardware and bought 2 TEEs a nipple and plug and some thread seal tape. they had no crosses. but its all 1/8" Npt so what i'ma do is buy a male 1/8" BSPT to male 1/8" NPT and a male NPT to female BSPT. and everything should work out.





This post has been edited by southwest2118: Jan 22, 2006 - 4:43 AM

[presure2]

why all the diffrent fittings??
just so you know, brass is about the worst thing you can use for those types of application, it is very weak and WILL crack.
if all that stuff is what i think it is (turbo oil feed) then you need to take all those back where you got them from, and get this:
http://tunertoys.zoovy.com/product/OTODK
its got the proper thread pitch for the head and allows you to keep your stock pressure switch.
the return needs to be 3/4" ID