![]() |
![]() |
![]() |
|
Enthusiast ![]() Joined Dec 28, '05 From Norway Currently Offline Reputation: 0 (0%) ![]() |
I'm getting tired of trying to find a diagram for my 1995 GT (3s-ge) ECU. I have to find the speed sensor wire where it plugs into the ECU for my navi system. I just can't figure out where it is. I have also tried to read chinse diagrams.
![]() Diagram 1 Diagram 2 -------------------- ![]() |
![]() |
![]() |
|
Enthusiast ![]() Joined Dec 28, '05 From Norway Currently Offline Reputation: 0 (0%) ![]() |
Ok. I'm a bit confused. The gauge cluster is hold in place by four screws, right? And one of the wires should be connected to one of them? So this wire is earthed? Maybe this is dumb
![]() -------------------- ![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Oct 10, '03 From Wichita, KS Currently Offline Reputation: 5 (100%) ![]() |
QUOTE(eliaz @ Jan 29, 2006 - 3:28 PM) [snapback]386119[/snapback] Ok. I'm a bit confused. The gauge cluster is hold in place by four screws, right? And one of the wires should be connected to one of them? So this wire is earthed? Maybe this is dumb ![]() The four screws I'm talkin' about are the ones that secure the actual speedometer GUAGE to the guage CLUSTER. Once you get the guage cluster out you'll see the four screws on the back and the traces on the circuit "board" that connect to the plug. This post has been edited by WannabeGT4: Jan 29, 2006 - 4:33 PM -------------------- ![]() Project ST204.5 99.88946% complete... |
![]() ![]() |
Lo-Fi Version | Time is now: July 18th, 2025 - 9:49 AM |