![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() Joined Oct 7, '05 From Kansas Currently Offline Reputation: 0 (0%) ![]() |
My newly installed ct-26 or something else with my setup is acting up a bit.
For what reason i haven't discover yet my car decides to start boggin down really bad and and dies. Check engine light is on. It happens after i get on it a little. I accelerated (not a ridiculous amount honestly..) through an intersection and got up to about 50 mph and was just going constant 50 or so down the road and it started boggin. I let off the gas and coasted and then shiffted back into 5th and it bogged and died. Assure you i didnt miss shift and kill it. Similar thing happend later that night. with no coasting after it starts to bog. If i let the car sit off for ~5 min it starts up and goes fine. If i try to start it before i let it sit long enough it bogs up and down around 600 rpm and then dies. All i have installed is the turbo and all the neccessaries and an oil pressure gauge. Possible facts that could help diagnosis: i have the supra mkIII injectors oil pressure gauge only (got boost gauge today) no timing or fuel controllers to speak of. no intercooler. It was about 40 degrees the night it bogged and died. I haven't driven over 3200 rmp since and it seems to run ok. At stop lights or signs @ idle the oil pressure reads like 2 psi. My thoughts.. Turbo wheel is not spinning freely and bogs the exhaust gas and kills the car. Boost or pressure somewhere is leaking and messing up the whole rhythm of the car. I can drive the car around like a granny and nothing goes wrong but I didnt turbo my car to drive slower than I can accelerate on my bicycle. Help!!!!!!!!!!!!!!!!!!!!!!!!!! |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Aug 31, '02 From Philadelphia, PA Currently Offline Reputation: 8 (100%) ![]() |
QUOTE(epinasty @ Feb 5, 2006 - 3:48 PM) [snapback]389233[/snapback] NEED seems pretty excessive considering buriens kit doesn't have a intercooler. Got bigger fuel pump i just wired the boost gauge and I have the 2 bar map. I said i have all the necessities. The gauge is a new sunpro electric. One wire to sending unit comming from oil sender just like you have pressure2. One to radio fuse since im putting in a new head unit when i get a harness. and of course a ground to the frame. It usually sits at about 25, 26 lbs when i give it the slightest bit of gas. It seems a little messed up. it sounds like you bought the basics really cheap off ebay or somewhere, and just couldnt wait to put them on. if you keep cutting corners like this, your motor will pop, like presure2 said. dont take any examples from the burien kit, its far from complete or what people would call a correct setup. as far as your stalling problem. it sounds like you have a huge vac leak somwhere in your system, thats causing the car to stall out. -------------------- 15PSI - 30MPG - Megasquirt Tuned
|
![]() ![]() |
Lo-Fi Version | Time is now: July 24th, 2025 - 5:41 AM |