Feb 23, 2006 - 5:40 AM
|
|
|
Enthusiast Joined Feb 16, '06 From Philadelphia Currently Offline Reputation: 0 (0%) |
I am getting ready to install new speakers in the rear panels of my car (98 covertible). I cannot for the life of me figure out how to get the side panels off that cover the speakers. Does anyone have any ideas or suggestions. Do I have to take the seats out? I can only find one screw near the seatbelt harness but I can't believe that just one screw holds that entire cover in. Any assistance would be appreciated. Thanks
|
![]() |
Feb 23, 2006 - 6:03 PM
|
|
|
Enthusiast ![]() Joined Apr 19, '05 Currently Offline Reputation: 0 (0%) |
I ran into the same problem with my car when I was installing new rear speakers. You need to move the edge of the seat, where the seat cushion meets the plastic panel. Don't actually take off the seat cushion, just push the foam inwards towards the seat belt buckles, and you will see 2 or 3 plastic screws holding the side panel in (just like the plastic screws that hold the trunk inserts in). After you get those out, there are two visible screws near the rear windows. One has a snap on it. Take of both of these screws, then just wiggle the side panel out.
|
tenexe rear speakers 98 convertible Feb 23, 2006 - 5:40 AM
95celgt u forgot the 2 screws at the bottom of the panel, ... Feb 23, 2006 - 11:06 PM
Scott QUOTE(95celgt @ Feb 23, 2006 - 8:06 ... Feb 24, 2006 - 12:40 AM
tenexe QUOTE(95celgt @ Feb 23, 2006 - 11:06... Feb 24, 2006 - 11:03 AM
madmods Your bottom seat pulls out. Top seat is bolted in ... Feb 23, 2006 - 11:34 PM
juBz86 you dont need to take out the rear seat but it mak... Feb 24, 2006 - 1:41 AM
juBz86 the bottom piece just pull it straight up. dont be... Feb 24, 2006 - 11:18 AM
juBz86 the bottom piece just pull it straight up. dont be... Feb 24, 2006 - 11:18 AM![]() ![]() |
| Lo-Fi Version | Time is now: November 25th, 2025 - 3:27 PM |