7afte update Options

[southwest2118]

Today i started to really install the turbo. took the front bumber
off the radiator and the stock exhaust mani spent like half the
day on one bolt- striped it -drilled it- broke it. my turbo exhaust
mani is very diffearnt from NIK's old 7afte i also had to cut the
top left hand side of the mani. the down pipe has to go between
two refrigerant lines they are really close i was thinking ...i drain
the refrigerant then with a torch heat up the line and bend it a
little. how much dose it cost to get it filled?

[southwest2118]

i'm in at my parents house .. no cam..sister should get hers back tomarrow.

today i tryed to get the down pipe welded i took them the downpipe piece with the autozone flex pipe thing on it they said bring in the car so i drove it with the flex pipe just going stright down LOUD they wanted 90$ just to do the downpipe .**** that right.. ..:)even with stright pipe you can still hear the turbo spining up LOUD??i'm new to this sound ME LIKES.. but right now the turbo is not connected to the intake mani so it's just blowing....

so right now i have some low impedance injectors so what resisters do i need from radio shack to make them work????????----MAIN QUESTION OF THE DAY---if some body can give me a part number...I would be very thankful..10watt 10ohm ?? also what wire do i connect them to?


so i'ma go try to find a cheaper place tomarrow for the downpipe.... i should also have some pictures

This post has been edited by southwest2118: Mar 14, 2006 - 2:41 AM