6G Celicas Forums

Welcome Guest ( Log In | Register )

> Tranny/Clutch Issues
post Mar 12, 2006 - 7:28 PM
+Quote Post
3sgte@daspeedof

Enthusiast
*
Joined May 23, '05
From Sauga
Currently Offline

Reputation: 0 (0%)




So I waited on my mr2 tranny, I got the alltrac shifter cables & axles, I go to install everything, and I get the tranny bolted to the block, the passenger side engine mount is in, all the wires are hooked back up. I have the intermediate shaft hooked up, and I go to install the shifter cables before I go any further, and it won't shift into 1st, 3rd, 5th, or reverse.

So what I want to know is
1. If the front & rear mount are not hooked up will it cause the tranny to be so far out of place that I can't put it into those gears.
2. My clutch pedal won't move an inch is there something I'm missing or forgetting to do what would cause my clutch pedal to not move like that.
 
Start new topic
Replies
post Mar 14, 2006 - 3:48 PM
+Quote Post
3sgte@daspeedof

Enthusiast
*
Joined May 23, '05
From Sauga
Currently Offline

Reputation: 0 (0%)




I went and got alltrac cables, so my issue is that they might not be alltrac shifter cables or that they are from a 4th gen celica or alltrac.

I'm going to bleed my clutch and see if there is any improvement, I know it was moving before I hooked up the tranny, but that's not moving now.

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: August 1st, 2025 - 5:20 PM