Tranny/Clutch Issues Options

[3sgte@daspeedof]

So I waited on my mr2 tranny, I got the alltrac shifter cables & axles, I go to install everything, and I get the tranny bolted to the block, the passenger side engine mount is in, all the wires are hooked back up. I have the intermediate shaft hooked up, and I go to install the shifter cables before I go any further, and it won't shift into 1st, 3rd, 5th, or reverse.

So what I want to know is
1. If the front & rear mount are not hooked up will it cause the tranny to be so far out of place that I can't put it into those gears.
2. My clutch pedal won't move an inch is there something I'm missing or forgetting to do what would cause my clutch pedal to not move like that.

[3sgte@daspeedof]

lol, you must think I'm an idiot, I'm really not, I did the swap my self, I have hooked up the cables to the shifter linkage, and left them unhooked from the shifter in the cabin, I can shift through the gears, but when I put the cables onto the shifter they are about 10 milimeters too short, to put it into gear.