SPEC Clutch Kit for the 3SGTE Swap, 3sgte swap using the 5sfe tranny Options

[jcbass7]

I called Spec and ordered my clutch kit for the swap. They actually have a part number now for this set-up, the information is as follows:


Spec's tech phone number:

1-205-491-8581

I talked with Justin, who helped me out a ton, great guy to deal with.

his extension is 108


The part number for the clutch kit is:

ST6225S


The SECOND (2) in that part number is the number to reference what stage clutch you would like. I chose a stage two clutch, which i was told will hold 400 ft/lbs of torque.

If you wanted a stage 3 clutch the number would be as follows:

ST6235S

or a stage 1 (not recommended if you plan to add any power to the 3sgte) would be:

ST6215S

etc.
etc.



For reference this is what Lagos put together:

You need the

5fse - disk
5sfe - throwout bearing
5sfe - alignment tool
3sgte - pressure plate
3sgte - flywheel

The clutch kit includes all BUT the flywheel.

EDIT: The clutch kit they sell is basically a kit for the 3sgte that will bolt onto the 5sfe Tranny. It is the 3s disk with the 5s spline count


For a ballpark figure, i paid 389$ for the stage two clutch kit and after shipping a total of 413$


Hope this helps future swappers!

This post has been edited by jcbass7: Jun 7, 2006 - 2:55 PM

[SPEC01]

Yes there is a lightened flywheel. Part # ST09A Price is $419. Weight is roughly about 10lbs. It is aluminum and that is the only flywheel we offer for 5SFE motor. As for the clutch I think you would be best in a 2+ holds 305 flywheel torque( part # ST733H). Great daily driver clutch and great peddle pressure. As far as the pics the flywheels all pretty much look the same. You can see what they look like at www.specclutch.com just go to the products section and check out flywheels.


Thanks,
Justin