Kinda need some help Options

[dustin15brown]

Ok everyone. I was installing the last Tein S-Tech lowering sring and I rounded off the sway bar bolt. The actual inner piece that requires an allen key/wrench is the rounded off part. What are my options for fixing this? Anyone else have this problem? I'm kind of at a standstill until I come up with something and I'm fresh outta ideas.

Any ideas? Any one?

This post has been edited by dustin15brown: Jun 19, 2006 - 1:14 PM

[Bitter]

grind it out or drill it. same thing happened to my prizm.


if you dont have one, get an electric impact gun. i beleive pepboys has a nice kit for $100 that includes a 400 or 500lb gun and a flip socket set.

then get a good set of metric impacts, sears has a set thats 12-27mm for about $60. trust me, you'll love it! you're not going to get those knuckle bolts off by hand as easily as you can with the impact. also while you're out get a 4 foot peice of thick wall gas/water pipe from the hardware depot, in whatever size fits over most of your wrenches and your breaker bar. also, get a breaker bar! ratchets dont like to be piped and they will break!