3sgte wiring question Might have it solved!, it found a home, need confirmation!!! Options

[jcbass7]

well after two days of an intense puzzle known as wiring.. i have all but one connecter identified and plugged in. It is at the driver side of the intake manifold and i cannot seem to locate the other place to hook it in. Im guessing its a sensor or something that i dont have but im not sure.. here are some pics:






ALSO: what do i do about this oxygen sensor ? it is the lower of the two on the Down pipe:



This post has been edited by jcbass7: Jun 30, 2006 - 2:08 PM

[jcbass7]

if thats the TVIS in one of the pics above, then the blue one goes there, but the blue and gray plugs both have the exact same connector, and i can't find a single gray connector like that in my wiring diagram... i emailed doc tweak about it since he did my wiring, but haven't heard back yet..

what baffles me is that in my wiring diagram one of the wires from that plug goes into pin # 3 on the largest ecu plug.. the book states its a wire that leads to the ignitor... but my ignitor is already hooked up.

this is the only thing holding me up from dropping the beast in so i hope i figure it out soon


thanks for the help so far everyone

hmm wait whats the difference between a

TVIS and TVSV maybe one goes to one and the other to the other.. if so then i think i may be missing one of the two.. i have whatever it is in the pic abaove thats broken..

if anyone has a pic of both that may help