Vaccum Issues with swap, diagrams i have are bogus. Options

[jcbass7]

So i have the engine about to drop, but now with the wiring almost out of the way i have some vacuum issues to figure out.. and the diagrams i have are completly useless.

I have three vacuum lines that i am unsure of right now. Two come out of the top of the intake manifold and proceed across the sticker that says toyota... well here is a pic instead:




and the other comes out on the passenger side of the intake manifold near the throttle body heres a pic:


and another pic



it is the one on the left of the two, (the one with the black spiral cover thing)

thanks in advance

Jesse

This post has been edited by jcbass7: Jun 28, 2006 - 9:30 AM

[jcbass7]

not sure if its the cold start injector or not, but i still can't locate the place to mount that end of it, ill keep searching...

[jcbass7]

not sure if its the cold start injector or not, but i still can't locate the place to mount that end of it, ill keep searching...

found it. im an idiot. directly under the intake manifold, had to take the throttle body off to get to it, but its all set

thanks guys