6G Celicas Forums

Welcome Guest ( Log In | Register )

> After a few blown fuses
post Jul 10, 2003 - 5:15 PM
+Quote Post
REDCELICA

Enthusiast

Joined Jul 10, '03
From usa
Currently Offline

Reputation: 0 (0%)




I recently got my 99 GT red celi :-D
I just got my first MOD and is two 10" DEEP red lights and I tried to install them after trying to figure out where and how to wire them I ended up wiring it to the HAZZARD E LIGHTS wires but the problem is that it is always ON when car is off and ON so I bought a switch and the switch has 3 ittle holes to wire them wires biggrin.gif now these 2 cables are ON all the time so I wired the switch and everything seemed to work fine until I realized that when I turned the neons OFF the signals and back lgiths were ON confused.gif confused.gif I did not grounded the swithc thinking that one of those 2 cables from the HAZZ light is already...

Do you think that's what's wrong??
any other way to wire this things????

thanks...

BEN.
 
Start new topic
Replies
post Jul 11, 2003 - 1:30 AM
+Quote Post
AudioFreak

Enthusiast
**
Joined Dec 19, '02
From West of Atlanta
Currently Offline

Reputation: 1 (100%)




Get your power from the battery. Fuse the cable and run it to a relay. Set the relay up to turn on the lights when you give the relay a ground.

On a bosch style 30 amp relay.
Connect pins 85 and 30 to the power cable from the battery.
87 goes to the lights 12v+ connection.
86 goes to a switch. Connect the switch so that when it's on it provides a ground to pin 86.
Pin 87a isn't used.

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: September 22nd, 2025 - 9:44 PM