SWAP IS NEAR COMPLETION...BUT, but car refuses to Fire Options

[CelicaSTX02]

Hey guys, I need help..................The swap is close to completion, but it would not fire.

-Yes, the engine turns over
-Yes, all the fuses are checked and are in working order
-Yes, the fuel pump starts
-Yes, there are oil in the motor and all the fluids
-Yes, everything is grounded to the firewall and are secure
-Yes, the ECU is sending a signal to ignite
-DG Performance did the wiring harness
-Yes, the ignitor have been checked and is in working order

-No, the wiring harness does not send a signal to the ignitor when tested
-No, the coils does not get a signal to charge up.

Our only option as of right now is to check all the wires in the wiring harness to see if there was a cable cross over or something. I don't think the wiring harness is the problem, because DG Performance did it....but I am not sure what else to check.

If you have any ideas or give me some suggestions of things to check......please let me know. Thank you in advance.

This post has been edited by CelicaSTX02: Aug 14, 2006 - 3:39 PM

[bigal004321]

Is this something dave does quite a bit...cuz i am sending my harness to him....and i dont want to have to mess with it after i have payed for it

Bigal