3sgte wiring Options

[Punisher]

Looking for someone here who has put a 2nd gen 3sgte (W/ 2nd gen harness) into their 6gc GT.

I need help with the wiring.. not literal help (I'm not a wiring n00b).. but someone who has done the wiring themselves successfully and can point out all of the stuff I need to wire in and what not.

I could do this myself however it will take longer than if I have someone that can just tell me exactly what it is I need to do. Only looking for someone who has done this and really knows what is up.

If someone here can help me out I would be willing to send you a few dollars through paypal. This will definitly help me get the swap done faster.

I have all of the wiring diagrams and ecu pin outs for both the 94 gt and the 91 alltrac which I got everything from. Not a wiring n00b either but the less time I have to spend figuring out wiring the better.

My AIM SN is either punisher3sgte or fumbduck0

If yo u don't have AIM but another service, send me a PM.

This post has been edited by Punisher: Aug 19, 2006 - 10:47 PM

[brianforster]

i dont think anybody is "new" to wiring, its just strip solder heatshrink..

were just saying that people like DG and tweak make a living off of this stuff, so id say its a little unfair to them as businessmen and everyone else for paying them.

its like when people pay to have there car dyno tuned and people ask for the fuel maps as a base.. its like shhyea.. right..

edit: im not tryin to be rude or anything here, and also i think that the wiring issue has been covered before in searches.

This post has been edited by brianforster: Aug 19, 2006 - 11:13 PM