 gt 4 rear end in 94 gt |
 Aug 20, 2006 - 5:21 PM
|
 
|
 Enthusiast  Joined Jan 29, '06 Currently Offline Reputation: 0 (0%)  |
it will work right, only thing is gas tank and exhaust need to be moved ?? can the exhaust be ran up alongside the drive shaft?
|
 |
Replies
|
Aug 20, 2006 - 8:09 PM
|
|
 Enthusiast Joined May 22, '03 From NOVA Currently Offline Reputation: 16 (100%) |
the floor pan, suspension setup, control arms, mounting points are all different and dont exist on a GT car...
the GT/ST floors are lower then the GT4's rear so it doesn't allow as much clearances under the car either |
|
Aug 21, 2006 - 5:56 PM
|
|
|
Enthusiast Joined Jan 29, '06 Currently Offline Reputation: 0 (0%) |
does any of the all trac cars rearends fit well? 5th gen rear end? i've seen someguys conversion but i don't know where to find it now. ?
|
|
Aug 22, 2006 - 10:11 AM
|
|
 Enthusiast Joined Dec 27, '03 From Nor Cal Currently Offline Reputation: 0 (0%) |
QUOTE(freakyre33c @ Aug 21, 2006 - 10:56 PM) [snapback]471354[/snapback] does any of the all trac cars rearends fit well? 5th gen rear end? i've seen someguys conversion but i don't know where to find it now. ? And what difference would it make... sourcing a rear-end from an alltrac? All of the toyota multi-link rear-ends are pretty much the same. Conversions have been done... but require chopping the rear end into bits then welding everything up again... -------------------- "It's ok to be naked girl... I'm an artist!"
1995 AT200 Celica ST: stocked out daily driver... 1984 AE86 Corolla GT-SR5: silvertop 20V 4AGE project car jacked up with goodies... 1991 SW2x MR2 n/a: bare bones hardtop model soon to be... |
Posts in this topic
freakyre33c gt 4 rear end in 94 gt Aug 20, 2006 - 5:21 PM
DEAMON from what i know that the GT4 body fram is 3inches... Aug 20, 2006 - 5:41 PM
freakyre33c awd Aug 20, 2006 - 5:56 PM DEAMON try 2 get the rear dif demitions and see if the mo... Aug 20, 2006 - 6:11 PM presure2 everything has to be custom fabricated or transfer... Aug 20, 2006 - 6:13 PM freakyre33c well just down to the nut, how much chopping is th... Aug 22, 2006 - 3:11 PM presure2 QUOTE(freakyre33c @ Aug 22, 2006 - 4... Aug 22, 2006 - 3:31 PM playr158 start with sumthing like this Aug 22, 2006 - 3:51 PM freakyre33c im a fabricator too i would be fine with that. i j... Aug 22, 2006 - 7:46 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: October 26th, 2025 - 4:35 PM |