![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Jun 26, '03 From Wisconsin Currently Offline Reputation: 0 (0%) ![]() |
My aftermarket deck was wired to use the stock amplifier so I have RCA's going into my deck. The deck has more amplification then the factory, and I am losing a lot of potential sound from my Eclipse deck/Alpine Speakers. How would I rewire this? Would it just be easier to rerun all new speaker wire, or clip wires off from the factory amp?
This post has been edited by Andason: Jul 19, 2003 - 2:04 PM -------------------- i am awesome
|
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Jun 26, '03 From Wisconsin Currently Offline Reputation: 0 (0%) ![]() |
Any recommendations for an amplifier for these four speakers
Alpine SPS-170A 6-1/2" Type-S Series Coaxial 2-Way Speaker • Peak Power 200W • 40W RMS Power • Frequency Response: 35Hz – 30kHz • Strontium Ferrite Magnet • Aluminum-Coated Woofer Cone • Rubber Surround • Nomex® Spider • 1/2" Balanced Dome Tweeter • Neodymium Tweeter Magnet • Variable Swivel Tweeter • 16cm Mounting Adapter Included -------------------- i am awesome
|
![]() ![]() |
Lo-Fi Version | Time is now: September 22nd, 2025 - 5:53 PM |