3sgte build plan., complete parts listing for what I wanna do. am i over looking anything Options

[x_itchy_b_x]

Ok, heres the list so far

Turbo: Hx35w check
3" turbo back check
Hydra Nemesis EMS v2.5 with Wideband and Boost control solenoid.
2.5" intercooling piping
600 x 300 x 3" bar & plate FMIC check
SARD 800cc injectors
Wolfcatz sidefeed rail
ATS Racing Throttle Body Inlet
Walbro 255 check
Cometic HG check
ARP headstuds check
wolfcatz FPR
fidanza cam gears check
external WG

now this comes down to me being lazy. i dont wanna pull the head again. but i will if if i have too.
eagle springs only 93 bucks from ats
and ferra 1mm OS valves 174 bucks. thats cheap for the power and rpm gain without floating.
then some 264's because i still want daily drivablity. but yeah im not going ghetto and doing things right woo woo and i have support from my dad who wants to build this with me.

Uh.. what am i forgetting.

This post has been edited by x_itchy_b_x: Sep 18, 2006 - 7:39 PM

[x_itchy_b_x]

How much CFM does that turbo push? What are your horsepower goals?

"The Holset is the only turbocharger available with a "Map Width Enhancement" groove. This groove is machined into the inlet of the compressor housing to allow air to be fed to the second set of blades on the compressor wheel. This increases efficiency and overall air flow by more than 10% over a standard compressor housing". honestly there arent any good maps for it. i found this one.
but on average people see 450-500flyhp on pump gas at 18-22psi. my goals are anything over 350whp the closer to 400wp the better. i also want to be realiable though. check out this site selling the holset hx35 for dsm use. www.dsmparts.com

This post has been edited by x_itchy_b_x: Sep 19, 2006 - 5:15 PM