Sep 21, 2006 - 11:25 PM
|
|
|
Enthusiast ![]() Joined Aug 22, '06 From Daygo Currently Offline Reputation: 0 (0%) |
i installed a new deck in my car and ever since then my dash light has not been working. i checked the fuses, and im not sure if this is the right fuse but the fuse that is labeled panel was blown. it was a 7.5 mini fuse so i went and bought another one. i put it in and i start the car, and then that one blows as well. do u think it has something to do with my deck?
This post has been edited by Snodalo: Sep 21, 2006 - 11:39 PM |
![]() |
Sep 25, 2006 - 11:43 AM
|
|
![]() Enthusiast ![]() ![]() ![]() Joined Jan 13, '06 From UnderTheGround403 Currently Offline Reputation: 2 (100%) |
a short is when there is part of the wire that is exposed (in the middle or something) that is not supposed to be showing, and when it touches something metal it grounds (some wires aren't meant to be grounded)
to check for shorts have a look at all the wires and make sure there are none with a stripped spot on them somewhere, and usually yes, you can just wrap it with e-tape, or some heat-wrap. if it is bad enough you might have to run a new wire. if your probel is your ground, then re-ground it. if you take some sandpaper and sand a bolt hole down to bare metal and then screw your ground in there that works really good. |
Snodalo no dash lights CMON SOMEONE HELP Sep 21, 2006 - 11:25 PM
Killswitch I had the same problem. If you look at you wiring ... Sep 21, 2006 - 11:48 PM
phonex98 id had the same problem... and actually it WAS som... Sep 22, 2006 - 12:22 AM
Bitter if the fuse re-blows, then you have a short and ne... Sep 22, 2006 - 12:36 AM
Snodalo im pretty sure theyre not connected. i know there ... Sep 22, 2006 - 2:01 PM
Killswitch Make sure no wires are exposed. Or that any wires ... Sep 23, 2006 - 12:57 PM
Snodalo When i had my old car, my amp would only work when... Sep 25, 2006 - 4:27 AM
Snodalo thanks alot Sep 25, 2006 - 5:11 PM
BlackCelicaGT94 My dash has been blown for about 2 years now. I li... Sep 25, 2006 - 5:50 PM
Daftboy Sounds like a wire is exposed take out the the dec... Sep 25, 2006 - 10:09 PM
nate95 i had this same problem when installed my cd playe... Sep 26, 2006 - 1:31 AM
Snodalo ****, that doesnt sound good... ive been too busy ... Sep 27, 2006 - 12:38 AM
nate95 ya just take it all out and check all the wiring ... Sep 27, 2006 - 3:09 PM
XS4lv1Truch0x its that 7.5 amp fuse.
replace it but before you ... Oct 7, 2006 - 11:51 PM![]() ![]() |
| Lo-Fi Version | Time is now: January 10th, 2026 - 6:55 PM |