Installing a direct port Water injection., Help needed to place the nozzles... Options

[snakeloa]

Hello everybody,

i got a few questions again and might need some help

I ordered a "Direct Port Water injection" from here:
Enginerunup

Now i have to see where i can mount the nozzles on my intake manifold....

Well my mechanic wants to place them at the bottom end:


But i think that might affect the full atomization process?!?
As it is a direct port WI it should be one nozzle per runner. But where. And as far as i heard there is not much space to place them!!!

Here is a pic of a ST205 engine:

and especially of the runners



So where would you place these nozzels? And keep in mind that the nozzles have these huge checkvalves... so they are quite big.

And where is ourAir Intake Temperature Sensor?

cheers Joerg

[snakeloa]

This is what i just wrote to Greg as my mechanic told me that there would be enough space to mount them higher but he cannot reach this area with his fingers or a tool to tighten the nut.

Hello Greg,

thank you for your reply. Well for me it seems that the area where my mechanic wants to mount the nozzles is "very" close to the chambers!!!

But the problem is as far as he told me. That he has got a problem mounting them higher up the runners as the nozzels are build up like a screw and a nut. That means that he only has to drill a hole and then hold the nut on the inside of the runner and start screwing in the other part from the outside.

BUT the problem is we would like to get up higher with the nozzles but his fingers are not 20 cm long. Do you know what i mean. How did you achive to mount them in the middle of the runners. Please take again a look on the forum pictures i posted.

cheers Joerg