![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() Joined Jul 31, '03 From GA Currently Offline Reputation: 0 (0%) ![]() |
I just bought my 6th gen (96 ST) not to long ago. Not knowing when the most recent oil change was I decided to go ahead and do it. I went and picked up an oil filter (Purolator $3.50---good choice?) and I have some Castrol GTX 10w 30. Get under my car and find the oil filter(beneath the exahuast manifold) and think I find the drain bolt. Basicaly just about 12 inches below the filter. REally i just want to veriffy this is the right bolt. Also is that oil and filter a good recomendation for my car ( 138,000 miles).
*edit*I tried to undo the bolt and just couldnt get it off. I"m going to try again in a little bit. Would much prefer to do this myself. Cormudgen |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined May 12, '06 From Wilmington, NC Currently Offline Reputation: 45 (100%) ![]() |
my oil cap on my 5sfe it says 10w-30
according to the teacher of my auto class, if a car came with a factory recommendation of 10w-30, then you should use only that until the warranty runs out, after that, he said 10w-30 would probably give better gas milage while 10w-40 would probably make the engine last a bit longer. I use mobil 1 synthetic 10w-30 and toyota filters at 150K -------------------- ![]() 94 GT - Sold -------- 69 Pontiac Lemans - Sold 88 Alltrac - Sold ---- 04 WRX - Sold 00 GT-S - Sold ------ 91 Miata - project/drift car 95 GT - Sold -------- 96 GT - New Daily Drive |
![]() ![]() |
Lo-Fi Version | Time is now: September 12th, 2025 - 9:38 PM |