3sgte with GT Tranny., I need sugestion on clutch Options

[y2komar]

what's up.
I am in the process of gathering all needed parts for my 3sgte swap to 94 GT
Okok ok
From what I read i will need a GT clutch disk and I a pressure plate for a 3sgte engine... RIght??

Well can anyone give me suggestion on what to buy.

Part numbers will help greatly, and maybe a good place to buy them.

thanks everyone

I have a 2nd gen 3s from japan. Are all 2nd gen all the same

[x_itchy_b_x]

wait im sorry if i was misleading. the GT Pressure plate will not bolt up to a 3sgte flywheel.

What you need is:
A 3sgte pressure plate
A 3sgte clutch disc with 5sfe tranny splines.

spec sells this as a kit made especially for us.

read the stickies, its all in there

QUOTE
Lagos wrote:
Clutch:
if using the gt tranny with the 3sgte motor, you will need:
5sfe disk (or a custom made 3sgte disk, with the splines for the 5sfe tranny)
5sfe throwout bearing
5sfe alignment tool
3sgte pressure plate
3sgte flywheel (or just get your stock one resurfaced)

if you are going to use an mr2 turbo tranny, then all you need to do is buy a clutch kit for a 90-93 turbo mr2.

becareful when buying clutch disks for the 5sfe tranny. a stage 1 disk for the 5sfe is not the same thing as a stage 1 disk for the 3sgte. so if you get something like a stock oem clutch or a ACT street disk, it probably will not hold the power you need to put down.
if you call up a company like Spec or Clutchmasters and tell them about your project, they can make you a custom disk that can hold the power you will make and have the correct spline count that you need.

There we go thanks lagos.