Speed Source poly engine mounts, this goes out to Forgmann Options

[urbandork]

FORGMANN ur mail box is full lol. ive been told ur the guy to ask when it comes to the speed source poly engine mounts.

Which ones do i get? the n/a mr2 one or the st165 one? and also ive hear some of the mount must be modified, whats if n e thing must be modified?

btw i have a st205 motor mated up to an s54 tranny.

im running the st205 front mount and the s54 tranny rear mount.

i looked under the car and lined up the tranny mount from the st205 tranny and it looks like it may be able to fit with the s54 tranny mount bracket....... the st205 tranny mount is about an inch and half to the left then the s54 tranny mount (the rubber circle part) however looking at the bracket on the tranny and the stock s54 mount it looks like i have about an inch and half of space where i could move it to the left.

heres a rough drawin of what it looks like.




can i jsut use the gt4 rear mount ive been told it wont line up with the s54 tranny braket however it looks like it will.

has anyone tried it?

[FORGMANN]

hey,
i used 185 poly mounts installed into st205 front and rear mounts .. they work but required a lot of modding .

speed-source ships 2 thin poly and 2 thicker poly units you use on specific mounts but on st205 mounts you have to use 4 thin and speed-source doesn't ship that set at this time ..

regarding your set up.. you might condsider other poly inserts that fill in mounts .. i am not sure if any other speed source mounts will work ...

most mounts are same diameter just thickness is different ..

btw if you order any mounts get SS clutch line too .. top notch stuff ..

i am going to carl's shop next year when my st205 is done and might see if he can rearrange poly mounts and offer a thin set for st205 mounts .. with these you engine will not move ..