![]() |
![]() |
![]() |
|
Enthusiast ![]() ![]() ![]() Joined Mar 20, '04 Currently Offline Reputation: 3 (100%) ![]() |
hey guys recently had my one of my e-brake cable changed and now when i pull my hand brakes I only get three clicks and its tight but the problem is when I let go of my brake pedals the car shifts alittle and then it stops sometimes it makes a weird noise. Any thoughts guys thanks in advance.
|
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined May 12, '06 From Wilmington, NC Currently Offline Reputation: 45 (100%) ![]() |
ok, I'm done. I re-adjusted mine so it goes up about 6-7 clicks now, but if I try hard, I can pull it up to 10... oh well, close enough for me. it took maybe 15 minutes. it wasn't hard. just like batman said, take out the shifter surround, remove the two screws, remove the two 12mm bolts inside the armrest, pull out the center console, remove the one 10mm bolt, loosen/tighten the other 10mm bolt, replace the 10mm bolt, replace the center console, replace the bolts and screws, replace the shifter surround, you're done!
the only thing I had a problem with was getting the center console back. there are two little tabs sticking out the front of it that go into two holes on the other part of the center console. in order to get them in, you have to position the center console behind the other piece, lift up the rear of it, slide it forward into place, then lower the back end of it. it wasn't hard once I figured it out. took me like 5 minutes to get it back in. This post has been edited by 6strngs: Dec 16, 2006 - 1:23 AM -------------------- ![]() 94 GT - Sold -------- 69 Pontiac Lemans - Sold 88 Alltrac - Sold ---- 04 WRX - Sold 00 GT-S - Sold ------ 91 Miata - project/drift car 95 GT - Sold -------- 96 GT - New Daily Drive |
![]() ![]() |
Lo-Fi Version | Time is now: July 24th, 2025 - 2:17 PM |