![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() Joined Dec 9, '05 From Bedford, TX Currently Offline Reputation: 11 (100%) ![]() |
My axle crapped out on me again. iono how, but i got a life time warranty at oreilly. So i finally got the time to get myself another one. I place the cv axle just far enough to where it lines up and then i hammer it with a rubber mallet at the end of the joint to get the snap ring in. This is the result
It's pretty far in but is that in enough? before i put tranny fluid in again. I just want to make sure. Thanks. This post has been edited by My2Celi: Dec 16, 2006 - 5:12 PM -------------------- ![]() |
![]() |
![]() |
|
Enthusiast Joined Jul 28, '06 From Los Angeles, CA Currently Offline Reputation: 0 (0%) ![]() |
Can you just slide it back out? When I put in my passenger side, you could feel when it was properly set in place.
|
![]() ![]() |
Lo-Fi Version | Time is now: July 9th, 2025 - 12:05 PM |