 Driver CV axle. *pix*, Is it in far enough? Plz take a look who have installed it before. |
 Dec 16, 2006 - 2:52 AM
|
 
|
 Enthusiast  Joined Dec 9, '05 From Bedford, TX Currently Offline Reputation: 11 (100%)  |
My axle crapped out on me again. iono how, but i got a life time warranty at oreilly. So i finally got the time to get myself another one. I place the cv axle just far enough to where it lines up and then i hammer it with a rubber mallet at the end of the joint to get the snap ring in. This is the result
 It's pretty far in but is that in enough? before i put tranny fluid in again. I just want to make sure. Thanks. This post has been edited by My2Celi: Dec 16, 2006 - 5:12 PM --------------------  <--- I miss :'' ( |
 |
Replies
|
Dec 21, 2006 - 12:00 AM
|
|
|
Enthusiast Joined Dec 9, '05 From Bedford, TX Currently Offline Reputation: 11 (100%) |
lol thanks. i got it all the way in the other night, but it makes the same noise as if it was a bad one. Could it be my mounts? errr. iono.
-------------------- <--- I miss :'' ( |
Posts in this topic
My2Celi Driver CV axle. *pix* Dec 16, 2006 - 2:52 AM
xelan Can you just slide it back out? When I put in my p... Dec 16, 2006 - 9:16 AM My2Celi i cant pull it out at all, but it just seem like b... Dec 16, 2006 - 1:40 PM xelan Does the rotor and all that assembly go back on fi... Dec 16, 2006 - 2:00 PM My2Celi i drove it today and it seems fine. Except from th... Dec 16, 2006 - 5:12 PM xelan Did you grease everything up when you put it in? O... Dec 16, 2006 - 5:36 PM My2Celi dont think i need to grease anything, cause its a ... Dec 16, 2006 - 7:47 PM
JesterDC QUOTE(My2Celi @ Dec 16, 2006 - 8:47 ... Dec 20, 2006 - 11:28 PM JesterDC QUOTE(My2Celi @ Dec 21, 2006 - 1:00 ... Dec 22, 2006 - 1:58 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: July 10th, 2025 - 11:02 PM |