Installing Gauges, Oil Pressure, Water Temp troubles Options

[jcbass7]

Searched and couldn't find what i needed.. (swap related so i posted here, sorry if it should be in the interior/elec)

I'm installing an oil pressure gauge and a water temp gauge..

they are both electric and were made by prosport.

My questions are... do i need to tap into things for the probes/senders or are there stock places i can bolt these into? Or..... should i tap the wires off of the stock sensors?

This post has been edited by jcbass7: Dec 23, 2006 - 4:40 PM

[DeW_H0e_GT]

i also found a new product..well not so new....

the greddy oil filter block w/ 3 outlets for the oil pressure/temp gauges...i found this is a good deal to install oil-based guages in a jiffy....

http://cgi.ebay.com/ebaymotors/GREDDY-TRUS...1QQcmdZViewItem

[eggman40]

i also found a new product..well not so new....

the greddy oil filter block w/ 3 outlets for the oil pressure/temp gauges...i found this is a good deal to install oil-based guages in a jiffy....

http://cgi.ebay.com/ebaymotors/GREDDY-TRUS...1QQcmdZViewItem

x1000 I love this thing... the block adaptor made life waaay easy to install my gauges. I hooked up both oil temp and oil pressure using this thing. I also think it could double as a source of oil for a turbo for those boosting NA motors. I also seen similar products for people who have LS motors in their integra who want to run a b16 head, for LS Vtec otherwise you would tap into the head for oil... greddy FTW!

yea, those are pretty common too, only problem with that is clearance issues with a aftermarket DP on the 3s.

if you use a K&N oil filter you will have no problem. It is REALLY tight but there is just enough room to remove and replace the oil filter back on.