S-AFCII Initial Setup Options

[94celicadude]

ok, i just bought an S-AFCII for my 94 ST, its a 5spd, i have a few questions for the initial setup part of installing this gadget. First of all, what kind of sensor does the 7afe have? they give me a choice of 4: Hot wire, Flap, Pressure or Karman. And also how many? one i am guessing, but then again this is why i seek the expert advice from you all. Thanks a lot in advance.

[P5ycho]

quick question, does the RPM reading on the S-AFC2 read lower than what your actual tach says? Mine's doing that and I don't know if that's normal

i would just check where you ave taken the rpm reading from, ie where u have connect the rpm wire.
i believe there are 2 points at the ecu where u can do that.so it might be the case of connecting it to the other point.. and u can use the same wire to monitor the injector signal too.
if u want it to read exactly the same as your tach then i would extend the wire and connect it behind the tach itself...

This post has been edited by P5ycho: Jan 15, 2007 - 2:31 PM