My fogs quit working, EDIT: all better guys!! Options

[95CelicaST]

Well I hooked up my ST202 fog lights last night finally. I had the wires from my old PIAA fogs still routed down there, so I cut the connectors off the fog lights and the PIAA lines and put on some connectors. I plugged them all in and turned the lights on and they were working fine. I drove all last night and they were still all working fine. I came to work and parked and I could see that they were on because of the reflection off the bumper in front of me, but when I came back out shortly after they were not working. I checked the connections and they look fine. I didn't wrap the connections in electrical tape yet, but the entire connection is incased in plastic and rubber, and it isn't wet.


hmmmm... any thoughts?

This post has been edited by 95CelicaST: Jan 26, 2007 - 7:19 PM

[95CelicaST]

So i assume i should go and buy some new fuses tommorow? I think it needs at least a 15 though, because i remeber i blew a 10 (or it may of been a 5) I'll just get a multi pack of fuses and start with 10 and if that blows, i'll move up, so on and so on. but it might not blow. Like i said i'm almost postive it was just a short. -cnelson

no no no no no. You do NOT replace a 10amp fuse with a 15. You do NOT. You must use the same amp fuse or LOWER.