Gauge wiring...how did you run your wires?, Lotek tripel pillar Options

[Valo666]

So...how did you run your wires for your gauge install? Im going to be installin my gauges soon (finaly). For the power wires im thinkin of tappin power off the cig lighter just because it only has power when the cars on. As for running the wires to under the hood, i was gonna use the grommet in the drivers side fender well.

Im gonna be runnin a set of Stewart Warner guages. I have a volt meter, oil pressure, and A/F ratio. I know how to install the oil pressure and volt. But for the A/F do i just splice the wire onto the o2 sensor wire???

Any help would be great.

[Negative]

Of what? The connectors or the A/F gauge hooked up? If the gauge - not much to see. You will see the wire go inbetween the two connectors on the o2 sensor. Inside it's just wrapped around the appropriate lead. I've had it that way for like 2 years now and no problems. I used the Megan A/F gauge as it gives a good reading with a needle instead of a lightshow. Love that gauge - except almost impossible to read in the daytime in Tx.