mr2 trans. conversion update, Not so good. Need some help..please Options

[toyotacrazy]

Ok so I just got my mr2 turbo transmission in my car and took it for a spin today. There is a loud grumbling noise/vibration on acceleration and decel. only. Im feeling like its drive axles, but I had them apart and lubricated them and they looked fine. On the driveres side I did use the mr2 inner space and boot assembly. But I used the mr2 inner shaft that goes into the transmission. I used a full spacer (OEM axle spacer) on the passenger side. I didnt use one on the driver side. When I have the front jacked up and spin the wheels the side Im turning spins ok. The other side doesnt move unless I go to the other side and move it by hand. Everthing seems in place and tight. With the car on the ground the axles look straight. I used the st205 rear and drivers motor mounts. Any ideas what may be wrong?????? Thanks

-toyotacrazy

This post has been edited by toyotacrazy: Mar 4, 2007 - 2:08 PM

[Dr_Tweak]

Are you sure all your lug nuts are tight? Seems like a silly question, but that will cause exactly what you're describing.

-Doc