mr2 trans. conversion update, Not so good. Need some help..please Options

[toyotacrazy]

Ok so I just got my mr2 turbo transmission in my car and took it for a spin today. There is a loud grumbling noise/vibration on acceleration and decel. only. Im feeling like its drive axles, but I had them apart and lubricated them and they looked fine. On the driveres side I did use the mr2 inner space and boot assembly. But I used the mr2 inner shaft that goes into the transmission. I used a full spacer (OEM axle spacer) on the passenger side. I didnt use one on the driver side. When I have the front jacked up and spin the wheels the side Im turning spins ok. The other side doesnt move unless I go to the other side and move it by hand. Everthing seems in place and tight. With the car on the ground the axles look straight. I used the st205 rear and drivers motor mounts. Any ideas what may be wrong?????? Thanks

-toyotacrazy

This post has been edited by toyotacrazy: Mar 4, 2007 - 2:08 PM

[toyotacrazy]

Yes I got it in with 2 OEM spacers. And drove the car. I unbolted the lower ball joint with the 2 nuts and 1 bolt. I made 3 spacers all different sizes so I can hopefully get it back on the road tonight. Any suggestions what size I need? Thanks for the interest!