6G Celicas Forums

Welcome Guest ( Log In | Register )

> Sound system question?
post Apr 30, 2007 - 11:23 PM
+Quote Post
XS4lv1Truch0x

Enthusiast
****
Joined Dec 9, '05
From Long Beach
Currently Offline

Reputation: 1 (100%)




ok so check this out

iif i were to hook up a 3000 watt mono amp max to a 600 watt sub *its 2 subs*

would it damage the subs if i had the gain set at like 25 percent?

and would i have to change the wire running from the battery to the amp cause right now i think im using 16 gague wire? is it a must if im not going to have the amp at full blast?


--------------------
Is this good enuff 4 ya? :D

IPB Image
 
Start new topic
Replies
post May 1, 2007 - 11:33 PM
+Quote Post
afroman



Enthusiast
**
Joined Feb 9, '03
From Sioux falls, South Dakota
Currently Offline

Reputation: 1 (100%)




QUOTE(pittfirefighter @ May 1, 2007 - 8:01 PM) [snapback]553086[/snapback]


that amp is not made to run at one ohm... one ohm stable is garbage... always go up one step from whatever the manufacturer says... so two ohms is the lowest... even at that though it will be pulling a lot of power.... manufacturer are liars....UNLESS its pheonix gold or crossfire or ED


That really made me laugh, im not sure where you came up with that but you have been wrongly informed again thanks for the laugh laugh.gif laugh.gif laugh.gif
-Aaron-


--------------------
user posted image

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: July 11th, 2025 - 8:36 AM