any one install a NEO on a 5s yet?? Options

[Valo666]

So, i bought my self a Apexi AFC Neo today, and am plannin on wiring it up on tuesday when i have class. Has any one wired one of these up to a 5s yet?? I know Steph got one wired up to her ST, but not 100$ sure about any one with a GT. i donno if its like the SACFII, but its got a 15 wire wiring harness, but it says for a non v-tec, non RB26DETT, and a non- karman sensor vehicle, only use 9 of the wires. So pretty much you only need these wires: IG power, IG power *again*, RPM, throttel, ground, ground, airflow/pressure sensor, airflow/pressure sensor and illumination *ie power*. Does any one have a pic of a 5S pinout that can highlight these wires for me? Thanks

Bryan

[6strngs]

yeah, I've got one in my car. and yeah, it's the same for the 5s as the one in the book. only thing is, my car is a stick, but it still had a 22 pin connecter for the third one instead of the 12 like people are saying the manual tranny's have. maybe cause my car is cali spec?



I followed pressure2's how-to install a safcII and the wire colors are all the same.



This post has been edited by 6strngs: May 20, 2007 - 6:11 PM

[Dr_Tweak]

yeah, I've got one in my car. and yeah, it's the same for the 5s as the one in the book. only thing is, my car is a stick, but it still had a 22 pin connecter for the third one instead of the 12 like people are saying the manual tranny's have. maybe cause my car is cali spec?



I followed pressure2's how-to install a safcII and the wire colors are all the same.

The 5th gen Celica GT manual uses a 12-pin, all 6th gen GTs use a 22-pin. The ST manual uses a 12-pin, however.

-Doc