Zephyr kit question, To all those w/ zephyer kits Options

[Phr0z3n664]

How hard is it to remove the front zephyr lip from the front bumper? how many bolts or was adhesive used to put it on, if it is bolted how hard is it to remove, just a few screws or what?

I just wanted to know for future reference, to see if I could remove it for easier acces to fit a jack under the car, and also for everday driving cuz the roads suck here in Louisiana.

This post has been edited by Phr0z3n664: Aug 25, 2003 - 11:24 PM

[Phr0z3n664]

I think I might have found a solution if I lower it, I can just install two bolts in the front going throught the stock bumper, not upward but directly into the bottom half of the bumper, that way I can easily unscrew it. I will also have the two bolts by the wheel wells.

Just have to wait until I have the money aside to take it to a bodyshop.

I used a pic of cragspiders car to show where the bolts would go, notice the green dots: click here to see example pic

This post has been edited by Phr0z3n664: Aug 26, 2003 - 10:50 PM