Parts for AWD, Using a ST185 Options

[MaskedMan]

Ok well i had a question and have been doing some thinking. If i have a full ST185 to take apart, would that mean i would have most of if not all of the parts needed to do the AWD conversion to an ST204? I'm assuming i would have to buy new suspension though as im not sure the ST185 shocks will bolt right up to the ST204, but i haven't tried yet. Well the reason for this being is that basically some of you know i have an Alltrac, but recently, it appears that my engine had seen it's last day as i checked compression on it and it's like 90, 30, 30, 60. The chassis also has quite a bit of rust on it, and probably isn't going to last too many more years. So i am willing to just cut my losses and use whatever parts on it that i can, since i doubt i will be getting much for selling the car as a whole right now.

[MaskedMan]

Well i was just wondering what else i would possibly need other than a fuel cell. I remember reading somewhere that the ST185 AWD set up is practically the same as the ST205 set up is in terms of bolt up locations. So if i weld in the neccesary brakets using the ST185 set up, i should be able to upgrade to the ST205 compenents if i feel the need to in the future.