3rd gen swap wont start Options

[RUNNIN-LOW]

starter wont crank...just clicks from the inside.(of car).there seems as if there is no power going to the starter..wierd thing is that the radiator fan stays spinning.rechecked all wiring harness plugs and ground..starter wont crank over..checked starter today and it is working fine. please can anyone help with this problem....wiring harness was made by dr.tweak so i trust that it is fine..ooh yeah i did and have checked all the fuses like 30 times already even have one of my buddys do it like 10 times..everything is right...

This post has been edited by RUNNIN-LOW: Jun 8, 2007 - 11:26 PM

[scothaniel]

I had the single click when I had a bad ground (the connection on the trans was too loose).

When you say you can crank the motor manually, do you mean by jumping power to the starter directly?

Is the circuit opening relay (next to the ECU) engaging when you try to start it from the ignition switch?

This post has been edited by scothaniel: Jun 12, 2007 - 11:45 PM

[toyotacrazy]

I had the single click when I had a bad ground (the connection on the trans was too loose).

When you say you can crank the motor manually, do you mean by jumping power to the starter directly?

Is the circuit opening relay (next to the ECU) engaging when you try to start it from the ignition switch?

By crank manually I mean put a wrench on the crank pulley and make sure the engine will spin over.