Quick Gt-four question, all you gt-four /replica guys Options

[RbrtNdrws]

Hi guys,

I've got the gt-four bumper on my car with the stock hood until I can locate the gt-four hood. Anyway, I cut the stock crash bar and used it and right now I have the bumper bolted on at the fenders on either side and at the bottom with all of the underbody plastic.

Is there a special piece that I need to go on the top of the bumper? Right now I'm using the stock black plastic piece with the rubber seal and I have it screwed on near the headlights. Theres a gap in the middle, do I need to have something under the gap to keep the bumper held up or what?

If that's confusing I'll post a picture if it helps. Basically I'm asking how does the middle section attach if there is a 1/2 inch gap in between the bumper and the rest of the car.

Thanks,
Rob

[azian_advanced]

Is there a special piece that I need to go on the top of the bumper? Right now I'm using the stock black plastic piece with the rubber seal and I have it screwed on near the headlights. Theres a gap in the middle, do I need to have something under the gap to keep the bumper held up or what?

If that's confusing I'll post a picture if it helps. Basically I'm asking how does the middle section attach if there is a 1/2 inch gap in between the bumper and the rest of the car.

Thanks,
Rob

you'll need the bumper to hood seal and the metal retainer for it for the gt-four. or unless you're good at shaping and bending, you can shape out your stock one to fit the gt-four bumper (like what i did). though it's not gonna look 100% perfect... but should be suitable enough until you order the gt-four ones.


**ignore the gt-four emblem, that's gone now**


and as for the front bumper, most people used washers to raise the bumper, or what i did i used these long 2" bolts that match the threading of the stock bolts to raise it up. the bumper is clamped between the head of the bolt and a nut.



This post has been edited by azian_advanced: Jun 14, 2007 - 4:12 PM